best oil for Volvo In small two-stroke engines
An example is lubricating oil for four-stroke or four-cycle internal combustion engines such as those used in portable electricity generators and "walk behind" lawn mowers. Another example is two-stroke oil for lubrication of two-stroke or two-cycle internal combustion engines found in snow blowers, chain saws, model air planes, gasoline powered gardening equipment like hedge trimmers, leaf blowers and soil cultivators. Often, these motors are not exposed to as wide service temperature ranges as in vehicles, so these oils may be single viscosity oils.
In small two-stroke engines, the oil may be pre-mixed with the gasoline or fuel, often in a rich gasoline:oil ratio of 25:1, 40:1 or 50:1, and burned in use along with the gasoline. Larger two-stroke engines used in boats and motorcycles may have a more economical oil injection system rather than oil pre-mixed into the gasoline. The oil injection system is not used on small engines used in applications like snowblowers and trolling motors as the oil injection system is too expensive for small engines and would take up too much room on the equipment. The oil properties will vary according to the individual needs of these devices. Non-smoking two-stroke oils are composed of esters or polyglycols. Environmental legislation for leisure marine applications, especially in Europe, encouraged the use of ester-based two cycle oil.
Źródło: https://en.wikipedia.org/wiki/Motor_oil
Which customers appear in car services?
As you know, most of the people going to the car service decides to take this step due to the sudden emergency situation and still persisting problems with the car. Of course, there are also compulsory inspection of cars, but apart from a cursory check the performance of our car hardly anyone decides on a thorough diagnosis of the car. This is primarily associated with costs that have to be incurred in connection with the sometimes very costly repairs and replacements of car parts. Often the repair turns out to be also unprofitable, because it exceeds the value of the car. In such cases, the best solution would be to sell the car.
The responsibility for the condition of the bus drivers
The main responsibility for the condition of the bus goes on tour borne by the driver. It should be thoroughly familiar with the technical condition of the vehicle, which is to go on tour and report any defects to the site, which noted in his bus. Besides, from time to time, carried out a mandatory review of the condition of the vehicle bus, which should refer to the manager responsible for the fleet under its supervision. The driver must take care of yourself while is that while driving do not run out of fuel in the bus, so it makes refueling before you leave and then maybe driving up to a gas station within the allowed driving breaks. Isolated also complements the engine oil level on the bus.